Extreme SFP1G-SX-31-I Compatible 1G SFP Transceiver Module

Product Highlights

• Compatible alternative to Extreme SFP1G-SX-31-I
• 1G connectivity at 1.25Gbps
• Optical wavelength: 1310nm
• Specified reach: 2km
• Duplex LC / SMF/MMF interface
• Operating temperature: -40 to 85°C (-40 to 185°F)
• Factory compatibility verification and optical performance testing before shipment

Specifications

Applications and Optical Link Design

Typical deployments include switch-to-switch, switch-to-server and aggregation links inside a data hall or between adjacent equipment rooms. The Duplex LC interface connects to the specified multimode cabling, and the stated reach depends on fiber grade and link loss. Keep this interface on the matching multimode optical standard rather than connecting it directly to a single-mode wavelength or reach variant.

The industrial temperature rating makes this version appropriate for controlled outdoor cabinets, transport nodes and other installations exposed to wider ambient temperature variation. Adequate airflow, protected cable routing and host-platform temperature limits still apply.

For this multimode module, confirm fiber grade, modal bandwidth and total loss before commissioning. The 2km figure applies only under suitable cabling conditions. Inspect every Duplex LC mating point and match the remote optical standard.

Quality Assurance and Packaging

Before packing, the module receives interface inspection, identification and link checks. Protective packaging avoids pressure on the connector and latch. Customer references, rack groups and project packing lists can be added for volume orders.

Optical Acceptance, Diagnostics and Handling

For this model, the specified transmit-power range is -9~-3dbm; receiver sensitivity is < -21dBm. Digital diagnostics make later maintenance easier when baseline values are captured at installation. Save the initial readings with the port and OEM reference, then investigate meaningful changes rather than reacting to a single transient value. Diagnostic support depends on the host as well as the module, so unavailable fields should be confirmed with the platform documentation. Before every insertion, keep dust caps in place until the patch lead is ready, avoid touching the optical end face and use an appropriate inspection and cleaning procedure. Do not look into an active optical interface.

Data-Center Optical Design and Airflow

Select the module by optical standard, reach and rack layout. Check the complete fiber channel, including panels and connectors, and keep dense bundles from blocking front-panel airflow. Account for listed power consumption and preserve enough space to remove a module without disturbing adjacent links. For this model, the principal parameters are data rate 1.25Gbps, wavelength 1310nm, rated reach 2km.

Ordering Information

Quote HT part number SFP1G-SX-31-I together with OEM reference SFP1G-SX-31-I and quantity. Add the host model and software release when pre-order verification is required. Neutral labels, customer packaging and project-specific compatibility review are available on request.

Extreme Compatibility and Factory Testing

Factory verification starts with the expected SFP1G-SX-31-I identity and finishes with an operating host link. EEPROM data, diagnostic visibility and the stated optical parameters are assessed together. Equipment model, hardware revision and software release can be reviewed before dispatch where platform behavior is uncertain.

Frequently Asked Questions

Shipping and Lead Time

Standard configurations normally ship within one to three working days, with production lead times confirmed for larger quantities. International courier, air freight and sea freight are available; customer courier accounts and nominated forwarders are accepted.