Juniper Networks QDD-400G-ZR-M Compatible 400G QSFP-DD Transceiver Module

Product Highlights

• Compatible alternative to Juniper Networks QDD-400G-ZR-M
• 400G connectivity at 100/200/300/400 Gbps
• Optical wavelength: 1528.77nm-1567.13nm
• Specified reach: ＞600km
• Duplex LC/UPC / SMF interface
• Digital diagnostic monitoring: Supported
• Operating temperature: 0~70℃

Specifications

Applications and Optical Link Design

This coherent interface is suited to data-center interconnect, metro transport and managed DWDM links where the host platform supports the stated modulation and FEC modes. Design the optical line around the actual launch power, receiver range, OSNR requirement and span loss; the stated reach is not a substitute for a link-budget calculation. Use matching coherent modules and the appropriate DWDM channel plan at both ends.

Before deployment, check the host port type, supported data rate and firmware requirements. The 400G interface configuration must match the remote equipment; sharing a QSFP-DD housing alone does not make two transceiver types interoperable.

For this coherent interface, document the wavelength plan and modulation or FEC settings before commissioning. Measure span loss and verify adequate OSNR. Interoperability depends on compatible coherent modes as well as form factor, so another coherent part number must not be substituted without engineering review.

Quality Assurance and Packaging

Each QDD-400G-ZR-M compatible module is inspected, powered up and functionally checked before protective packing. Dust caps and individual trays shield the interface during transport. Customer references, rack groups and project packing lists can be added for volume orders.

Optical Acceptance, Diagnostics and Handling

For this model, the specified transmit-power range is -13~-7dBm. During commissioning, record the host diagnostic readings after the link has stabilized and compare them with those limits. DOM values are useful operational indicators, but they do not replace calibrated optical measurements when a link is marginal. Investigate unexpected loss through connector inspection, cleaning and a channel measurement before replacing the module. Diagnostic monitoring is listed as Supported. Before every insertion, keep dust caps in place until the patch lead is ready, avoid touching the optical end face and use an appropriate inspection and cleaning procedure. Do not look into an active optical interface.

Data-Center Optical Design and Airflow

Select the module by optical standard, reach and rack layout. Check the complete fiber channel, including panels and connectors, and keep dense bundles from blocking front-panel airflow. Account for listed power consumption and preserve enough space to remove a module without disturbing adjacent links. For this model, the principal parameters are data rate 100/200/300/400 Gbps, wavelength 1528.77nm-1567.13nm, rated reach ＞600km.

Ordering Information

When ordering, specify QDD-400G-ZR-M, QDD-ZRP-400G, quantity and intended host platform. Project labels can repeat these details for receiving and asset records. Neutral labels, customer packaging and project-specific compatibility review are available on request.

Juniper Networks Compatibility and Factory Testing

Factory verification starts with the expected QDD-400G-ZR-M identity and finishes with an operating host link. EEPROM data, diagnostic visibility and the stated optical parameters are assessed together. Equipment model, hardware revision and software release can be reviewed before dispatch where platform behavior is uncertain.

Frequently Asked Questions

Shipping and Lead Time

Standard configurations normally ship within one to three working days, with production lead times confirmed for larger quantities. International courier, air freight and sea freight are available; customer courier accounts and nominated forwarders are accepted.