For UAE project teams, the key is to match this exact configuration to the port schedule, optical budget and delivery documentation. This OS2 fiber patch cable carries a LC UPC interface on one end and a LC UPC interface on the other, factory terminated on OS2 glass and optically tested as an entire unit. The duplex zipcord build keeps the transmit and receive strands paired in one unit for fast, error-free patching.

Product Highlights

• 60% Shorter in Boot Length, and 30% Reduction in Overall Connector Length
• G.657.A1 Bend Insensitive Fiber with 10mm Min. Bend Radius
• Precision Zirconia Ferrule Connectors Ensure Low Loss
• Flame-Retardant Riser (OFNR) for Vertical and Floor-to-Floor Installations
• Color-Coded Cable Jacket for Easy Identification

Specifications

Bend tolerance in real cabinets

Patch fields are rarely kind to fiber. Patch cords path through tight managers, sharp tray corners and crowded vertical channels. Because the bend-insensitive glass in the assembly tolerates a 10mm fiber bend radius, a hurried routing decision during a night servicing window does not turn into a measurable penalty on the connection.

Where single-mode jumpers earn their place

Single-mode patching carries the links that leave the room: campus backbones, carrier handoffs, long runs between buildings and each wavelength-multiplexed service. The OS2 glass in the assembly is the identical group used in the outside plant, so this jumper does not become the weak point of the optical budget. At 1310 and 1550nm the attenuation stays a fraction of a decibel per kilometer, and this connector pair adds less than 0.3dB when the end faces are clean and seated.

Short boot connectors for tight spaces

The shortened boot shrinks this connector footprint behind this panel, which matters in high-density frames where the bend space behind every port is measured in millimeters. The shorter lever arm additionally reduces the side load on the ferrule when the cord is dressed sharply to the side.

Length Options

Standard length options cover the common patching routes: 1m (3ft), 1.5m (5ft), 2m (7ft), 3m (10ft), with custom length offered beyond the list. Specifying the measured path length keeps the slack out of the manager and the strain off these connectors.

Quality Control and Testing

Each assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on every cable, and end-face geometry is inspected for consistent physical contact. This cable ships with dust caps on the two connectors and the test result offered on specify.

Ordering and Factory Support

Refer to this setup by connector pair, fiber mode and length when ordering a quotation. For configurations outside the listed options, mixed connector families, jackets, identification or project packing, send the need with the inquiry and the factory will verify the build prior to production. Our UAE project support can review the requirement with Shenzhen production before a formal quotation is issued.