A ready to install MTP® Elite Female jumper: 24 Fibers, OM3 50/125μm, Plenum (OFNP). Pre-termination means no polishing, no epoxy and no curing time on site - just route the cable, plug in both ends and bring the link up.

Standard lengths are 1m (3ft), 3m (10ft), 5m (16ft), 7m (23ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft), 30m (98ft) and 40m (131ft). Because we are the manufacturer, any other length between or beyond these steps can be produced on request, with your choice of jacket color, labeling and packaging.

Product Highlights

• MTP® Elite Female (Non-Pinned) to MTP® Elite Female (Non-Pinned), 24 Fibers
• OM3 50/125μm, bend insensitive fiber
• Insertion loss ≤0.35dB (0.15dB Typ.), return loss ≥20dB
• Type A polarity (straight through)
• 3.0mm Plenum (OFNP) round cable
• Minimum bend radius 7.5mm
• Ten standard lengths from 1m (3ft) to 40m (131ft), custom lengths built to order

This jumper is intended for high density data center patching. A 24-fiber MPO interface is the standard for 100GBASE-SR10 CFP, CFP2 and CPAK modules, and is equally at home in structured trunking between panels. It works equally well in new structured cabling builds and in day-to-day moves, adds and changes where fast, error-free reconnection matters.

This model is supplied in the polarity shown in the specification table. Type A maps fiber 1 to fiber 1 straight through, Type B reverses the array, and Type C swaps adjacent pairs. Female (pinless) connectors mate with panels and cassettes; male (pinned) versions are available for direct transceiver connection. Tell us your cabling scheme and we will build the matching variant.

Please reference 24FMTPOM3 in your enquiry. The 1m (3ft) version is the standard model; Our sales team can also advise on polarity, gender and jacket choices if your project documentation is not final yet.

We have manufactured fiber optic assemblies since 1995. MPO and MTP cabling is one of our core lines: fiber counts from 8 to 144, single mode and multimode, UPC and APC polish, trunk, jumper, harness and breakout formats. Send your drawing and we turn it into a ready to install assembly.

Each assembly is coiled, capped and sealed in an individual bag, then packed into foam lined export cartons. Test reports can be attached per unit or per batch, and carton marks follow your shipping instructions.

Our test routine covers insertion loss, return loss and ferrule end face inspection on every assembly. Because testing is done in-house, custom variants receive exactly the same verification as standard models.